Page 9 of 15
Charge unit fully prior to each use.
Follow all instructions published by the battery manufacturer and the manufacturer of the
equipment in which the battery is installed.
Make sure the area around the battery is well-ventilated.
Never smoke or allow a spark or flame in vicinity of the engine or batteries.
Batteries contain acid and produce explosive gases. Shield eyes and face from batteries at all
times.
An incorrect connection may cause sparking, igniting explosive gases and causing severe injury.
Make sure you have the proper polarity before jump starting.
Before use: Ensure the vehicle's batter is 12 V. Ensure the vehicle's electrical systems are off.
Remove all jewelry and metallic items such as rings, bracelets, necklaces, and watches when
working with batteries. Batteries produce a short-circuit current high enough to cause severe injury
when touched.
Keep plenty of fresh water, soap and a supply of baking soda on hand in the area of the batteries
in case of contact with battery acid. Baking soda neutralizes lead acid battery electrolyte.
The product is supplied with a rechargeable, sealed lead acid battery. This battery is self-
contained and not consumer replaceable. Batteries must be disposed of properly when they no
longer hold a charge.
Operating Instructions
⚠
WARNING
SPARK AND EXPLOSION HAZARD
Risk of explosive gases. Working in the vicinity of a lead acid battery is dangerous. Batteries
generate explosive gases during normal battery operation. Do not smoke, use matches, or a
cigarette lighter while near batteries. Do not handle the battery while wearing vinyl clothing. The
static discharge from vinyl clothing rubbing together may ignite explosive gases, causing injury
and/or property damage.
Do not operate the jumpstarter in compartments containing batteries or flammable materials, or in
locations that require ignition-protected equipment.
The 12V DC outlet does not automatically turn off the power supply to the DC appliance, even if
the internal battery of jumpstarter is discharged.
Disconnect the 12V DC appliances after use to avoid over discharge of jumpstarter
’s internal
battery.
Operating 12V DC Appliances
1.
Check battery capacity status by pushing the “BATTERY” button to ensure that the battery is fully
charged.
2.
Press the “DC” button to activate the DC sockets. You can see the indication on the LCD screen.
Then open the DC outlet plastic cover.
3. Plug the power cord of DC appliance into the DC socket.
4. Turn ON the DC appliance.
5.
Press the “DC” button to turn off DC power.
