Page 7 of 13
Specific Operation Warnings
⚠
WARNING
Do not exceed the rated load capacity. The rated load capacity of the hoist must not exceed the
rated load capacity of the trolley.
Ensure the path of the trolley is clear before installation.
Before each use, inspect trolley and verify that all wheels make substantial contact with the beam
flange and are secure. Adjust if necessary.
Only use on a flat, level surface.
Do not use to lift people or animals.
Not for use by or around children.
Operating Instructions
⚠
WARNING
Beam must be properly installed and rated for anticipated loads.
Do not install trolley on beams of unknown capacity.
Do not install trolley on damaged or deformed beams.
Trolleys are designed to be used with hoists of the same rated capacity. Never use a hoist with a
capacity greater than the capacity of the trolley.
Never subject trolley to a side pull or load. Load must be centered directly under the hoist / trolley
assembly.
Make sure the load is stable and secure before moving.
1. Measure the actual width of the “I” type beam.
2. The width between the wheels should be 6mm
wider than the width of the “I” type beam.
3. While using the trolley on the smallest size
“I” type beam, move the equalizer pin to the opposite
side of the chain so that to balance the trolley.
4. During operations, the trolley should not move too fast and should not overload for safety
consideration.
