Page 15 of 23
e) Remove the winch handle, reverse the handle, and install it. The handle grip should face the
operator.
f) Straddle base: Adjust to the desired width. Be sure the leg lock pin snaps into the leg.
g) Rotate the hold-down bar of the carriage.
2.
Loading the
Platform
a) Lay the load platform onto the forks.
b) Lift the front of the load platform and push it toward the carriage until the back angle is under
the lower fork mounting tube.
c) Rotate the load platform down until it locks into place over the forks.
3. Testing the Brake Operation (if equipped)
a) Press down on the food pedal to lock the brake.
b) Push the machine.
Result
: The wheels should not roll.
a) Pull up on the foot pedal to release the brake.
b) Push the machine.
Result
: The machine should move.
Operating Instructions
⚠
WARNING
•
Do not exceed the rated load capacity of 500lbs.
•
Do not use to transport people or animals.
•
Do not stand under or allow personnel under the load.
•
Do not lower the load unless the area below is clear of personnel and obstructions.
•
Check work area for overhead obstructions or other possible hazards.
•
Do not use a machine with a worn, frayed, kinked or damaged cable.
•
Do not use a damaged or malfunctioning machine.
•
Do not use a machine with less than 4 wraps of cable on the winch drum when the carriage is fully
lowered.
FALL HAZARD
•
Do not use as a personnel lifting platform or step.
•
Do not stand or sit on forks, load platform, or boom.
•
Do not climb on machine.
Summary of Contents for 61134
Page 19: ...Page 19 of 23 Parts Diagram ...
