(L) FAN SWITCH
Your Magnatrac HM 8000
comes
equipped
with
an
automotive type fan attached to its
external oil cooler. Turn fan on by
pulling switch to help reduce
hydraulic oil temperature in hot
conditions. Turn off fan during extensive use of
headlights to prevent excessive battery drain.
(M) HOUR METER
Meter will begin recording time
the moment the Ignition Switch
(O) is switched to Run.
NOTE
: The Engine does not
have to be running for the Meter to record
time...the Ignition Switch just has to be in the
Run
position. Always turn Ignition Switch
Off
and
remove key when leaving Crawler. This will
assure you that your Meter is recording only
actual running hours!
(N) TEMPERATURE GAUGE
This gauge records the hydraulic oil
temperature just as it enters the Traction Drive
Pump. Monitor this temperature so that it
does
not exceed 180 degrees
Fahrenheit.
If the oil temperature
exceeds 180 degrees,
stop
operating
the
Crawler, but allow the
Engine to operate at
medium speed to circulate the oil through the oil
cooler and lower its temperature.
(O) AMMETER
Measures electrical charge or
discharge to battery. If Ammeter
shows a discharge, shut down
electrical system by turning
Ignition Switch to
Off
and determine the problem.
(P) HYDRAULIC CIRCUIT CONTROL
The Hydraulic Circuit Control distributes flow
to the HC74 Hydraulic Circuit kit. This flow is
utilized for the PTO70 Power Takeoff option as
well as for other full flow and high pressure
accessories (snow blower, auger, stump grinder,
etc...). If the handle for the Hydraulic Circuit is
turned to the right, even just a little, the tractor will
not start, due to the #441 safety switch installed
on the unit.
Never defeat this safety switch!
9
FAN
PULL OUT
HOURS
OIL TEMP.
KEEP BELOW 180°
AMPS