BM57
Coated Clips over threads of the two bolts in-
stalled in Step #21 above.
Secure both #1905 Coated Clips with Flange
Nuts...finger tighten.
23) From “outside” #279 Grommet on “left end”
of #1645 Rear Brace, slide one end of #1733
Hose into Grommet and “behind” #1736 & 1737
Hoses previously installed. Route it down, forward
and to the right toward #1721 Pump.
Check that #1727 - 90 deg. Fitting on “top port”
of Pump points toward “left” Body Wall and #1726
- 45 deg. Fitting on underside port of Pump points
to “right rear” body corner.
[Note:
Do not tighten
lock-nut of either of these Fittings at this time.
]
Install two #1904 Coated Clips around #1733
Hose and loosely secure to Bolts indicated in pho-
tos.
24) Slip a #931 Hose Clamp over remaining end
of #1730 Hose and slip that end onto the #1726
Fitting below #1721 Pump...tighten Clamp only.
Attach end of #1733 Hose to #1727 Fitting above
Pump... tighten Hose only.
Slide #1717 Plate “rearward” to tighten #1725 Belt
and secure by tightening the four “fine thread”
Flange Bolts.
25) Use Photo (below) to clarify and identify crit-
ical parts and to further check your work.
26) Using four 1/4” x 3/4” long Flange Bolts and
Flange Nuts mount the #1719 Oil Tank to “top
rear” of the #1680 Rear Mount...tighten! Slip a
#931 Hose Clamp over remaining end of #1728B
Hose protruding from Grommet in Rear Brace. In-
sert one end of a #1734 Elbow into #1728B Hose.
1905
1721
1726
1727
279
1733
1904
1904
1737
1736
1730
1733
Location of:
Flange
Nuts
1733
1727
1721
1726
1730
1717
1725
931
1737
Flange
Bolts
1645
279
1733
1728B
1880
1680 279
1736
