5
Caster
Vertical
Adjustment
Ring
Caster
INSTALLATION, CONT’D: CASTER MANEUVERABILITY & ADJUSTABILITY
Note: This Page Only Applies To Models With
Lockable/Adjustable Features.
3. Caster Height: Raising and Lowering
Raise or lower casters (to adjust case height) by
rotating casters’ vertical adjustment rings.
Rotate vertical adjustment ring clockwise to lower
caster (and increase height of case).
Rotate vertical adjustment ring counter-clockwise
to raise caster (and decrease height of case).
4. Caster Rolling Capability: Unlocking
Important! Case is shipped with caster mechanisms
that are factory set at
ON
(locked) which prevents
case from rolling.
Unlock casters by pressing
OFF
on the caster
mechanism. See illustration at right.
5. Carefully Roll Case Down Pallet
Check that casters are lowered as far down as
they will go (as instructed on previous step).
Slide case to rear of pallet (see below illustration).
Caution! 2 people may be required
for this task!
Carefully lower to floor
(using ramp if available).
Slide pallet from under
case as required.
Maintain support of case
at all times while rolling
down ramp.
See illustration at right.
Press “OFF” Lever To
Unlock Caster (And
Allow Casters To Roll)
Pallet
Support case
while removing
from pallet
Ramp
