6
Caster
Tighten Set
Screws To
Lock Caster
Height In
Place
INSTALLATION, CONT’D: LOCKING CASTERS / TOE-KICK ATTACHMENT
6. Casters: Locking
After case is at desired position (and height),
use level to check that case is level and plumb.
Readjust height as needed (as instructed on
previous page).
Locking Height: After proper height (and positioning) of
case is attained, tighten the two (2) set screws to lock
each caster’s height in place.
Locking Movement: Then, to prevent casters’ rolling
capability, lock casters by pressing ON atop the “ON”
and “OFF” lever mechanism (shown at right).
Case will now be secured at its new location.
7. Toe-Kick Attachment
Toe-kicks are held in place with magnets suspended at
all four corners of the case.
After case has been moved into position and locked in
place, all four (4) toe-kicks must be attached.
See illustration below.
Press “ON” Lever To
Lock Caster In Place
(And Prevent Caster
From Rolling)
Rear Toe-Kick
Front Toe-Kick
Left Toe-Kick
Right
Toe-Kick
