5
INSTALLATION: TOE-KICK & REAR PANEL REMOVAL / REMOVING SKID BRACKETS AND BLOCKS
1. Remove Toe-Kicks
To prevent damage to case, front
and side toe-kick should NOT be
on case at shipment.
If they are, you must remove toe-
kicks from case before removing
case from skid.
Toe-kicks are held in place by
magnets only.
Place toe-kicks in secure locations
while removing case from skid.
After case has been rolled into
location, adjusted and locked in
place, toe-kicks may be returned to
case.
Note: Illustration at right is shown
without skid shown for illustrative
purposes.
2. Removing Skid Brackets and Blocks
Use Phillips driver to remove screws from
shipping brackets. Remove and discard
shipping brackets from skid.
Place J-bar/pry bar under base frame.
Raise case up from skid to take weight off
casters.
With case raised, lower casters all the
way down against skid (see next step for
detailed instructions on lowering or
raising casters).
Remove rubber shipping blocks.
J-Bar
Pry Bar
Shipping Bracket
Rubber Shipping
Block
Skid
Side
Toe-Kick
Side Toe-Kick
Front
Toe-Kick
