13
REAR SLIDING DOORS / REAR LEDGE
1. Rear Sliding Doors
Note: Rear sliding doors are not interchangeable.
There is an inner and outer door. The outer door must
be removed first and replaced last.
The outer door, is the right hand door (from the
service side/rear of case). It can be identified by a
stop located at the lower right hand corner to the
inside of the case.
Move the doors toward the center of the case.
Individually lift each door up toward the top of the
case and pivot the bottom of the door out.
Reverse to reinstall.
Caution
: Gently set doors down to avoid
marring, scraping, scratching or breakage.
Hinged
Support
Bracket
Shelf
Track
Hinged
Support
Bracket
-
1
-
-
2
-
-
3
-
-
4
-
Shelf Track
—— Rear Ledge Removal Steps ——
Note: For clarity, only Shelf Track is shown being
removed. Rear Ledge is attached to Shelf Track.
2. Rear Ledge
Rear Ledge is connected to shelf track. Illustrations
at right reflect step-by-step removal method (as
enumerated below).
1. Hinged Support Bracket is shown in
its standard upright position.
2 & 3. While upright, Rear Ledge must be
slid away from case and then rotated downward to
vertical position.
3 & 4. From the shelf’s lowered position, lift from
bottom edge upward to disengage shelf track
(and attached Rear Ledge) from bracket.
