3
OVERVIEW
This merchandiser is designed for dry heating operations
throughout the product area. The heat is generated from
electric rod well warmers, overhead ceramic heaters and
overhead ceramic metal halide lamps.
This merchandiser is designed for display of
perishable, unpackaged heated products.
This merchandiser IS NOT designed to heat products
up; product must be pre-heated PRIOR to its display.
Cases should be installed and operated according to
this operating manual’s instructions to ensure proper
performance.
Improper use will void warranty.
TYPE
This unit is designed for the display of products in ambient
store conditions where temperatures and humidity are
maintained within a specific range.
Ambient conditions are to be at 55% max. humidity
and maximum temperatures of 75 °F (24 °C).
INTEGRATED AVERAGE PRODUCT TEMPERATURE
The Structural Concepts® Fusion Service Deli
Merchandisers are designed to merchandise product
at an integrated average product temperature of
150 °Fahrenheit / 66 °Celsius.
COMPLIANCE
Performance issues when in violation of applicable
NEC, federal, state and local electrical and plumbing
codes are not covered by warranty.
See below compliance guideline.
WARNINGS
This page contains important warnings to prevent
injury or death.
Please read carefully!
PRECAUTIONS and WIRING DIAGRAMS
See next page for
PRECAUTIONS
and
WIRING
DIAGRAM
information.
WARNING
Ceramic Heaters and Ceramic Metal Halide Lamps Are Hot!
Turn Off or Disconnect and Allow to Cool
Before Servicing or Replacing.
WARNING
HOT
SURFACE
COMPLIANCE
This equipment MUST be installed in compliance with
all applicable NEC, federal, state and local
electrical and plumbing codes.
OVERVIEW / TYPE / TEMP / COMPLIANCE / WARNINGS / PRECAUTIONS / WIRING - PAGE 1 of 2
WARNING
Risk of electric shock. Disconnect power before servicing unit.
CAUTION! More than one source of electrical supply is
employed with units that have separate circuits.
Disconnect ALL ELECTRICAL SOURCES before servicing.
WARNING
ELECTRICAL
HAZARD
WARNING
Pans and Wells Are Hot!
Disconnect and allow to cool
before cleaning or removing from case.
WARNING
HOT
SURFACE
