INSTALLATION: FRONT GLASS ALIGNMENT & ADJUSTMENT (CURVED & FLAT FRONT GLASS)
10
—- Front Glass —-
Case with Curved
Front Glass
Case with Flat
Front Glass
LIFT
END
PANEL
CURVED
FRONT
GLASS
3. If FRONT-LEFT CORNER
is too close to end panel (or
hitting it), adjust levelers at
the BACK LEFT CORNER
of case DOWNWARD.
15. Setting The Case With Levelers
Begin with all levelers touching the floor so that case does not wobble when front glass is closed.
Front Glass Alignment
Proper alignment of the front glass is important to create and maintain a seal inside the case.
Air leaks caused by improper alignment will compromise the environment inside the case, and may
create condensation.
Follow the five steps listed below to assure proper front glass alignment.
2. Front-to-Back Leveling: Place a level on top of
case, perpendicular to front glass. Raise or lower
either side of case by rotating levelers to center the
level bubble. Double-check the side-to-side level.
1. Side-to-Side Leveling: Place a level on top of
display case (parallel to the front glass). Raise or
lower either side of the case by rotating levelers to
center the level bubble.
CURVED
FRONT
GLASS
END
PANEL
LIFT
4. If FRONT-RIGHT CORNER
is too close to end panel (or
hitting it), adjust levelers at the
BACK RIGHT CORNER of
case DOWNWARD.
5. After adjusting the levelers, open and shut the front
glass; verify again that front glass is properly aligned.
