START-UP / THERMOMETER / DISCHARGE AIR PROBES
8
1. Start
-
Up
When case is properly field wired, it will start
operating.
Supply power will start evaporator coil fans and
the compressor motor.
From the front of the case, raise the deck pans
and check to see that the evaporator coil fans are
all functioning properly (see next page).
When the case is in a start up mode (or has been
idle for a long period of time), the unit will require
approximately 30 minutes runtime in order to pull
down temperature.
2. Thermometer
Thermometer is located at rear plenum for
monitoring warmest air temperature.
Probe must be used to determine actual product
temperature.
See illustration below.
3. Discharge Air Probes
Remove cover to access discharge air probes.
General illustration of similar model shown below.
Your model may differ in layout.
Thermometer
Discharge Air
Probe Location
(Behind Plate)
Discharge Air
Probes
Discharge Air
Probe Cover
Discharge Air
Probe Location
(Behind Plate)
--- Discharge Air Probes - Sample Layout ---
Illustration Shown Reflects Remote Unit Only.
It May Not Exactly Reflect Every Feature or
Option of Your Particular Case.
