4
OVERVIEW / DISPLAY TYPE I vs. II / COMPLIANCE / WARNINGS / PRECAUTIONS - PAGE 1 of 2
WARNING
Hazardous moving parts. Do not operate unit with covers removed.
Fan blades may be exposed when deck panel is removed.
Disconnect power before removing deck panel.
WARNING
Risk of electric shock. Disconnect power before servicing unit.
CAUTION! More than one source of electrical supply is
employed with units that have separate circuits.
Disconnect ALL ELECTRICAL SOURCES before servicing.
WARNING
ELECTRICAL
HAZARD
WARNING
KEEP
HANDS
CLEAR
OVERVIEW
•
These Structural Concepts Reveal
®
cases are
designed to merchandise packaged products at
40 °F (4 °C) or less product temperatures.
•
Cases should be installed and operated according to
this operating manual’s instructions to insure proper
performance. Improper use will void warranty.
TYPE I vs. TYPE II ENVIRONMENTAL CONDITIONS
This unit is designed for the display of products in
ambient store conditions where temperature and
humidity are maintained within a specific range.
•
Type I display refrigerators are intended for use in an
area where environmental conditions are controlled
and maintained so that the ambient temperature does
not exceed 75 °F (24 °C) and 55% maximum humidity.
•
Type II display refrigerators are intended for use in an
area where environmental conditions are controlled
and maintained so that the ambient temperature does not
exceed 80 °F (27 °C) and 55% maximum humidity.
•
If unsure if your unit is Type I or II, see tag next to serial
label. See
SERIAL LABEL LOCATION & INFORMATION
LISTED / TECH INFO & SERVICE
section in this
manual for sample serial labels.
COMPLIANCE
•
Performance issues when in violation of applicable
NEC, federal, state and local electrical and plumbing
codes are not covered by warranty.
•
See below compliance guideline.
WARNINGS
•
Please read the important warnings in this document
carefully as they can prevent injury or death.
•
See next page for
PRECAUTIONS
.
COMPLIANCE
This equipment MUST be installed in compliance with
all applicable NEC, federal, state and local
electrical and plumbing codes.
ATTENTION
CONTRACTORS
CAUTION! IF YOUR UNIT IS SELF-CONTAINED, YOU MUST
CHECK CONDENSATE PAN POSITION & PLUG!
Water on flooring can cause extensive damage!
Before powering up unit, check and confirm that:
•
Condensate pan is DIRECTLY UNDER condensate drain.
•
Condensate pan plug is securely plugged into receptacle.
•
Overflow pan has plug connected to its box. Units with
optional Clean Sweep® MUST HAVE two plugs connected.
