Discotom-6
Instruction Manual
13
To set another stop position:
−
Press FORWARDS
to move the cutting table to the desired
position.
−
Press and hold the STOP
key and then press once on
FORWARDS
to set this position as stop position Then
release the STOP
key.
When the cutting table now reaches this position during
cutting, the cut-off wheel will stop and the cutting table will
return to its start position.
The set stop position will be cancelled when the power is
switched off.
Note:
the cutting table can be positioned with FORWARDS
and
BACKWARDS
. When the keys are held down, the cutting table
moves with increased speed of 20 mm / sec.
If the feed speed is set too high, the yellow FEED SPEED
REDUCED indicator (
) above the feed speed control flashes and
the feed speed is automatically reduced by 10%. Discotom-6 can
repeat this reduction up to 5 times.
Once the workpiece has been cut, the operator can reduce the feed
speed using the feed speed control until the overload indicator stops
flashing. Discotom-6 will then be able to cut another similar
workpiece without feed speed reduction.
Reduced Feed Speed
Summary of Contents for Discotom-6
