Discotom-6
Instruction Manual
23
Error
Explanation
Action
Cutting Problems
Discoloration or burning of the
workpiece.
The hardness of the cut-off wheel is
inappropriate for the hardness /
dimensions of the workpiece.
See Consumables section, under
heading ‘Cut-off Wheels’.
Inadequate cooling.
- Check that there is sufficient water
in the Recirculation cooling unit.
- Check the cooling water hoses.
Unwanted burrs
Wheel is too hard.
See Consumables section, ‘Cut-off
Wheels’.
Feed speed too high at the end of
the operation.
Reduce the feed speed near the
end of the operation.
Lack of support for the workpiece.
If possible support the workpiece on
both sides.
Cutting quality differs.
Cooling water hose clogged.
Clean the cooling water hose and
the cooling tube. Check the water
flow by turning the cooling valve to
cleaning position.
Cut-off wheel breaks.
Incorrect mounting of the cut-off
wheel.
- Check that the hole has the
correct diameter.
- Check cardboard washer on both
sides of the cut-off wheels and
replace if worn. The nut must be
tightened properly.
Incorrect clamping of the workpiece. Make sure that only the left quick-
clamping device is tight. The other
device should only press lightly.
Wheel is too hard.
See Consumables section, ‘Cut-off
Wheels’.
Feed speed is set too high.
Reduce the feed speed.
Inadequate cooling.
Check that there is enough water in
the cooling unit.
Check the cooling water hoses.
Summary of Contents for Discotom-6
