Discotom-6
Instruction Manual
11
Note
: The spindle for Discotom-6 is left-hand threaded. If Discotom-6
has been used for manual cutting, fasten the cutting handle with the
black handle at the right hand side of the machine before changing
the cut-off wheel.
Press and hold down the black locking knob on the right-hand
side of the cut-off wheel, turning the cut-off wheel until the
spindle lock clicks.
Remove the nut with a fork spanner. Remove the flange and the
old cut-off wheel.
Mount the new cut-off wheel.
Mount the flange and the nut. Tighten carefully and release the
locking knob.
Place the workpiece between the quick clamping devices and
the back stops.
Push the clamps towards the workpiece and lock the quick-
clamping devices with the locking handle.
Carefully close the protection guard.
Fitting or Changing the
Cut-off Wheel
IMPORTANT
Conventional cut-off wheels based on Al
2
O
3
/SiC abrasives should be placed
between two cardboard washers, to protect the cut-off wheel.
For maximum precision with diamond or CBN cut-off wheels, do not use
cardboard washers.
Clamping the Workpiece
IMPORTANT
The workpiece must be firmly held in the quick-clamping devices.
Summary of Contents for Discotom-6
