TegraPol-11/ -15
TegraForce-1
Instruction Manual
TegraPol-11 & TegraPol-15
Safety Precaution Sheet
To be read carefully
before use
1.
The operator(s) should be fully instructed in the use of the machine,
any connected equipment and accessories and the applied con-
sumables according to the relevant Instruction Manuals.
2.
The machine must be placed on a safe and stable table with an
adequate working height. All functions on the machine and any
connected equipment must be in working order.
3.
Operators should ensure that the actual voltage corresponds to the
voltage on the back of the machine. The machine must be earthed.
Follow the local regulations. Always turn the power off and remove the
plug or the cable before opening the machine or installing additional
components like TegraForce or TegraDoser-5.
4.
Connect only to cold water. Make sure that the water connections are
leak-proof and that the water outlet is working.
5.
Struers recommend that the mains water supply is shut off or
disconnected if the machine is to be left unattended.
6.
Alcohol based consumables: follow the current safety rules for
handling, mixing, filling, emptying and disposal of the alcohol-based
liquids.
7.
Make sure that the grinding or polishing discs are correctly mounted,
the driving pins engaged with the holes in the turntable.
8.
Keep clear of the rotating disc and the specimen mover during
operation. While grinding manually, be careful not to touch the grinding
disc. Do not attempt to collect a specimen from the tray while the disc is
running.
9.
If you observe malfunctions or hear unusual noises - stop the machine
and call technical service.
10.
The machine must be disconnected from the mains prior to any service.
Wait until residual potential on the capacitors is discharged.
11.
Do not cycle mains power more than once every three minutes.
Damage to the drive will result.
The equipment should only be used for its intended purpose and as detailed in the Instruction Manual.
The equipment is designed for use with consumables supplied by Struers. If subjected to misuse, improper
installation, alteration, neglect, accident or improper repair, Struers will accept no responsibility for
damage(s) to the user or the equipment.
Dismantling of any part of the equipment, during service or repair, should always be performed by a qualified
technician (electromechanical, electronic, mechanical, pneumatic, etc.).
