Stryker 0240080230, User Manual

  O
p

er

at

io

n

11

Before Printing

EN

The selector settings and paper rolls correspond as 
follows.
• LT (letter size):

SEPC-110

• A4 (A4 size):

SEPC-100

Page length on SDC HD and SDC Classic will be 
11 inches for both settings.

Note

Do not turn the selector beyond the range of the paper 
size marks when setting it. Doing so may result in 
damage.

5

Insert the paper holders into the paper roll.
A pink paper holder and a blue paper holder are 
provided with the printer. Insert these paper holders 
into the ends of the paper roll as shown in the figure 
below, with the pink paper holder in the end closer to 
the pink adhesive label and the blue paper holder in 
the end closer to the blue label.

Notes

• If the edges of the paper on the ends of the paper roll 

are not even, it is necessary to make the edges even 
(being careful not to crumple the edges while doing 
so) before placing the paper roll in the media tray. 
Using a paper roll with uneven edges can cause a 
malfunction.

• Do not strike or squeeze the paper roll. Doing so 

could break or bend the paper roll, and could result 
in poor printing quality.

• If inserting the paper holder into the paper roll is 

difficult when loading the paper roll, squeeze the 
roll from both sides to restore its shape.

• Correctly insert the paper holders all the way. 

If the paper holder selector comes off

The selector could come off if you drop the blue paper 
holder. Follow the procedure described below to 
reattach the selector to the paper holder.

1

As shown in the figure below, put the selector in 
the bobbin, line up the 

V

 mark on the selector 

with the arrow on the bobbin, and then push the 
selector into place.
The hook on the selector snaps into the notch on 
the bobbin marked by the arrow.

Note

There are two hooks on the selector: one indicated by 
the 

V

 mark and the other on the opposite side of the 

selector. Do not install the selector so that the hook on 
the side opposite of the 

V

 mark is in the notch on the 

bobbin marked by the arrow, as doing so could result 
in damage to the paper holder.

2

Turn the selector in the direction indicated by the 
arrow in the figure below until it clicks into place.

6

Load the paper roll in the media tray.

1

Open the media tray cover.

Blue

Pink

Paper holder

Paper 
holder

Label

Bobbin

Selector