Mis
c
e
lla
neo
us
19
Ink Ribbon and Paper
EN
When cleaning is completed, the paper is ejected and
the TRAY LOCK indicator is extinguished.
Notes
• The cleaning sheet is ejected with the paper.
Discard the paper and do not reuse it.
• To perform roller cleaning again, repeat the
procedure from step 3.
• If an error occurs, restart the procedure from step 1.
6
Make sure that the TRAY LOCK indicator is
extinguished then pull out the media tray.
7
Remove the cleaning ribbon.
8
Load the ink ribbon.
9
Insert the media tray into the printer.
This completes the cleaning procedure.
Notes
• As paper is used during cleaning procedures, the
specified number of prints possible with a paper roll may
be reduced if the same roll is used for multiple cleaning
procedures.
• If there is not enough paper, the paper on which the
cleaning sheet is attached may remain on the paper
holder after cleaning is performed. In such cases, be sure
to replace the paper roll.
• If the cleaning sheet is not ejected despite sufficient
paper, cut off the paper on which the cleaning sheet is
attached from the paper holder, and repeat the procedure
from step 2.
Ink Ribbon and Paper
Self-Laminate Color Printing Pack SEPC-100
Contains two color ink ribbons and two rolls of paper (A4-
size width).
Self-Laminate Color Printing Pack SEPC-110
Contains two color ink ribbons and two rolls of paper
(Letter size width).
Printable quantity
The number of printouts that can be made with a single set
of ink ribbon and paper is shown below.
For symbols on the accessories, see page 3.
Notes
• Do not change the ink ribbon and paper roll when they
are only partially used. Doing so can cause problems.
The number of printouts indicated above is not
quarantined.
• When the ink ribbon is used up, replace both the ink
ribbon and the paper roll.
• Destroy and discard ink ribbon per NIST Media
Sanitization Standards. (For customers in the U.S.A.)
Printing pack
SEPC-100
SEPC-110
Number of sheets
50 sheets
50 sheets
Print size
A4
Letter
