12
www.stryker.com
EN
0940-001-025 Rev-L
Guidance and manufacturer’s declaration - electromagnetic emissions
The Cast Cutter (REF 0941-000-000) is intended for use in the electromagnetic environment specified below. The customer or the user of the Cast Cutter (REF
0941-000-000) should assure that it is used in such an environment.
Emissions test
Compliance
Electromagnetic environment - guidance
RF emissions
CISPR 11
Group 1
The Cast Cutter (REF 0941-000-000) uses RF energy only for its internal function. Therefore,
its RF emissions are very low and are not likely to cause any interference in nearby electronic
equipment.
RF emissions
CISPR 11
Class A
The Cast Cutter (REF 0941-000-000) is suitable for use in all establishments other than domestic
establishments and those directly connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Complies
Guidance and manufacturer’s declaration - electromagnetic immunity
The Cast Cutter (REF 0941-000-000) is intended for use in the electromagnetic environment specified below. The customer or the user of the Cast Cutter (REF
0941-000-000) should assure that it is used in such an environment.
Immunity test
IEC 60601 test level
Compliance level
Electromagnetic environment - guidance
Conducted RF
IEC 61000-4-6
3 Vrms
150 kHz to 80 MHz
3 Vrms
Portable and mobile RF communications equipment should be used no closer
to any part of the Cast Cutter (REF 0941-000-000), including cables, than the
recommended separation distance calculated from the equation applicable to the
frequency of the transmitter.
Recommended separation distance:
d
=1.2√
P
150 kHz to 80 MHz
d
=1.2√
P
80 MHz to 800 MHz
d
=2.3√
P
800 MHz to 2.5 GHz
Where
P
is the maximum output power rating of the transmitter in watts (W)
according to the transmitter manufacturer and
d
is the recommended separation
distance in meters (m). Field strengths from fixed RF transmitters, as determined
by an electromagnetic site survey,
a
should be less than the compliance level
in each frequency range.
b
Interference may occur in the vicinity of equipment
marked with the following symbol:
Radiated RF
IEC 61000-4-3
3 V/m
80 MHz to 2.5 GHz
3 V/m
NOTE 1:
At 80 MHz and 800 MHz the higher frequency range applies.
NOTE 2:
These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures, objects and people.
a
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios, amateur radio, AM and FM radio
broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an
electromagnetic site survey should be considered. If the measured field strength in the location in which the Cast Cutter (REF 0941-000-000) is used exceeds the
applicable RF compliance level above, the Cast Cutter (REF 0941-000-000) should be observed to verify normal operation. If abnormal performance is observed,
additional measures may be necessary, such as re-orienting or relocating Cast Cutter (REF 0941-000-000).
b
Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
