7205-001-700 Rev-AA
EN
www.stryker.com
7
To Install the Attachment and Accessory
(continued)
NOTE:
If the attachment has notches, align one of the
notches with a tab under the attachment collar before
insertion.
2. Gently tug the attachment to make sure the
attachment is securely locked in the handpiece.
3. Install a wire, pin, tool, or cutting accessory as
required.
To Install the Battery Pack
WARNING:
ALWAYS slide the function switch
to the safe mode position before installing the
battery pack.
NOTE:
See the instructions for use supplied with
the battery pack and/or battery charger for charging
instructions and specifications.
1. Slide a fully charged battery pack into the
handpiece until the battery pack snaps into place.
2. Gently tug the battery pack to make sure the battery
pack is securely locked in the handpiece.
3. Test the operation of the handpiece by sliding the
function switch to the forward or forward/reverse/
oscillate mode position, and then depressing the
trigger.
To Operate the Handpiece
WARNINGS:
• ALWAYS slide the function switch to the safe mode
position when the handpiece is idle or when passing
the handpiece to another person.
• DO NOT change the position of the function switch
while the handpiece is operating.
