43
After the Codec is selected, the Control System places you in the “Active Call” interface with focus on the selected
Codec. When the incoming call is connected by the Codec, the call will be complete. Use the
Hang Up
button to
cancel “Wait for an Offsite Call” or to end a completed call.
Note
A “Wait for an Offsite Call” will time out after 30 minutes if a call has not been received.
12.6 Advanced Call Types
Broadcast and View call types allow a single direction video and audio call. The broadcasting endpoint initiates a
broadcast call and can select multiple endpoints to broadcast to. Endpoints can also choose to participate in a
broadcast call already in progress by using the “View” call feature. An unlimited number of endpoints can “View”
a “Broadcast” call.
12.6.1 Broadcast
A “Broadcast” call is initiated from the “Manual Dial” interface or can be stored as a preset and initiated from the
“Call Groups” interface. To create a Broadcast call do the following:
1. Navigate to the Manual Dial interface and select “Broadcast” from the “Connection Type” drop down
menu.
2. Select an endpoint from the “Room Name” drop down menu.
3. Press the green
Call
button to initiate the call.
To select another endpoint(s) to broadcast to, repeat the above procedure for each endpoint, selecting that
endpoint name from the “Room Name” drop down menu. Each time an endpoint is added, the number of viewers
listed on the “In Call With” button at the top right corner of the screen is updated (i.e., “In Call With 3 Viewers”).
To disconnect a “Broadcast” call, press the red
Hang Up
button below the keypad on the “Active Call” interface.
StockCheck.com
Summary of Contents for SwitchPoint Infinity 2
Page 35: ...33 S t o c k C h e c k c o m ...
Page 61: ...59 S t o c k C h e c k c o m ...
Page 80: ...S t o c k C h e c k c o m ...
Page 81: ...S t o c k C h e c k c o m ...
