background image

3. Set the top strap to the outer side of the respi-

rator and while holding the both ends of the

respirator with both hands, put the respirator
over the nose and mouth.

4. Hold the respirator with one hand, then put

the top strap over and settle it at top back of
your head with the other hand.

5. Pull the adjuster for the top strap, if neces-

sary, to adjust the length of the strap so that

the respirator can be attached firmly to your

face.

6. Adjust the tensions of the top and bottom

straps so that the respirator fits securely to 

your face.

7. Press the nose clip with fingers of both

hands so that the respirator can be attached

firmly to your nose.

 CAUTION

Do not hold both the top and bottom straps at the 

same time when donning; otherwise, your face may 

get injured by a corner of the respirator.

<Removing the respirator>

After removing the top strap over the back of your head, remove the bottom 

strap hanging around your neck.

 CAUTION

In order to prevent the secondary infection, special 

care must be taken not to touch the surface of the res

-

pirator when taking off the respirator.

Proper fitting

In order to achieve the original performance of the respirator, the respirator must 

have best fit. The user is required to be fit tested according to OSHA 29 CFR

1910.134 either qualitatively or quantitatively prior to use. Conduct a fit check 

following this procedure every time you put on the respirator.
1. Wear the respirator in the same manner as

you actually conduct during work.

2. Cover the respirator with two hands and exhale.

If it is not possible to cover the respirator

with both hands, use a polyethylene sheet

to cover the surface of the respirator, hold-

ing it down with both hands and exhale.

3. Check that no air leaks through respirator-to-

face seal when you exhale. If you feel air leak-

age, adjust the position of respirator and/or tention of straps until the air leakage stops.

 

WARNING

1. 

Before using the respirator in an actual operation, be sure to con

-

duct the inspection whether the respirator is properly fitted or not.

2. 

If it is not possible to ascertain that the respirator is properly fitted, 

do not use the respirator in an actual operation. Make the neces-

sary adjustments so that the respirator firmly fits your face.

If it is still not possible to ascertain that the respirator 

is attached properly after those adjustments, inspect

each and every portion of the respirator at a safe

place.

(Please refer to “Check before donning”.)

<For your reference>

If your face is too small to fit properly to your chin, it is recommended to put the 

bottom strap over the back of your head as shown in the figure below so that the 

respirator is tightly fitted around the chin.

Storage Method

Store the respirator in a clean, cool, dark and dry place.

 CAUTION

Do not pile up or bend the respirators to store ; it may 

cause problems such as fissures, deformation, etc.

Disposal Method

Put the used respirator in an airtight bag to prevent the particulate matters from

scattering before disposal in accordance with the applicable laws and regula-

tions.

NIOSH Approval Label

1-26-1, Nishigahara, Kita-ku, Tokyo

114-0024, JAPAN

+81-3-6903-7525

THIS RESPIRATOR IS APPROVED ONLY IN THE FOLLOWING CONFIGURATION:

TC-

Protection

1

Respirator

Cautions and Limitations

2

DD02-N95+S

84A-

9373

Surgical/N95

X

ABCJMNOS

1. Protection

N95 – Particulate Filter (95% filter efficiency level) effective against 

particulate aerosols free of oil; time use restrictions may apply.

2. 

Cautions and Limitations

A-

Not for use in atmospheres containing less than 19.5 % oxygen.

B-

Not for use in atmospheres immediately dangerous to life or health.

C-

Do not exceed maximum use concentrations established by regulatory 

standards.

J-

Failure to properly use and maintain this product could result in injury or

death.

M-

All approved respirators shall be selected, fitted, used, and maintained in

accordance with MSHA, OSHA and other applicable regulations.

N-

Never substitute, modify, add, or omit parts. Use only exact replacement

parts in the configuration as specified by the manufacturer.

O-

Refer to User’s Instructions, and/or maintenance manuals for information on 

use and maintenance of these respirators.

S-

Special or critical User Instructions and/or specific use limitations apply. 

Refer to User Instructions before donning.

Top 

strap

Adjuster

Nose

clip

For more information regarding the handling method of the 
product, please contact:

Head O

ce

1-26-1, Nishigahara, Kita-ku, Tokyo 114-0024, Japan

Tel : +81-3-6903-7525

Reviews: