9 Operating Instructions: DTP08(-Ex)
Section III
–
Unit Operation
IMPORTANT
Before using this unit, operators must read and understand this instruction manual. Failure to
observe the instructions in this manual will invalidate the warranty.
NOTE:
Personal Protective Equipment (PPE) must be worn at all times, see ‘Section I –
Correct
Use and Application’ for more information.
Initial Setup and Connecting to Drums
Each depalletiser is fitted with a universal drum catch which is adjustable in both height
(vertical) and reach (horizontal). This unique adjustability means that each lifter can handle a
wide variety of drum types and sizes commonly found in the workplace.
•
Ensure the rack is lowered fully so that all the vertical lift stroke is available; this is done by
turning the lowering lever anticlockwise.
WARNING
–
DO NOT ROTATE THE LOWERING LEVER CLOCKWISE AS THIS MAY DAMAGE THE
UNIT.
•
There are multiple rungs to which the drum catch can be secured, removing the lowest
pin allows removal of the catch from the rack. It can then be relocated and the pin
reinserted on a rung so that the catch is positioned below the lip of the drum.
•
Manoeuvre the depalletiser using the steering handle at the rear of the unit, being sure to
keep good posture. Operators should move gently while manoeuvring, whilst planning
ahead in good time. Ensure that when not in use, the unit is parked on flat and level
ground with the brakes engaged.
•
Line up the lifter with the centreline of the drum.
