Operation and maintenance manual
Product code: DTP05 (Ex)
Product description: Corner Drum Depalletiser
BESPOKE HANDLING EQUIPMENT LTD
Technical Support Line: +44 (0)1736 851050
Key safety requirements
1.
Do not use the unit unless you have read and fully understood the
operation and maintenance manual.
2.
This equipment is designed for use on level ground.
3.
Only handle drums that are in a good condition. Should the lip or any
other part of the drum be damaged, these should not be handled.
4.
When not in use the equipment should be parked in a safe location; if the
unit has brakes these should be applied.
5.
This product is to be used by one operator at a time and they must be
behind the unit at all times.
6.
For equipment which lifts drums, do not transport the drum at
unnecessary heights; the drum should be as close to the floor as possible
at all times.
7.
Do not allow other personnel to be in front of the unit when in use.
8.
The safe working load (SWL)/rated capacity should not be exceeded in
any circumstances.
9.
The equipment should be inspected at regular intervals, decided by the
operator’s company, for signs of damage or defects.
10.The unit must be inspected at least annually or after any unusual event by
a suitably competent person.
11.Ensure damaged or missing safety notices are replaced; these are
available from STS.
12.The manual forces relating to the use of this equipment are relatively low;
any doubts in this should be reported to STS.
13.If any operator is in any doubt of the correct suitability of the equipment
or has any problem understanding the instruction manual then they
should contact STS for technical support.
14.Installation of third-party equipment which affects the performance of the
equipment requires the written permission of the manufacturer.
15.Upon delivery equipment should be inspected for transit damage. Any
damage should be reported to STS and the equipment should be
quarantined and not used.
16.If the unit supplied is the ATEX model, ensure earthing chains are securely
fitted and are in contact with the ground at all times; also wheels should
be kept clean and free from debris.
17.The manufacturer shall not be held liable in case of faults or accidents due
to negligence, incapacity, installation by unqualified personnel or improper
use.
