SMD-300 Selective Pulse Metal-Detector User Manual
STT Group - Special Technique & Equipment
Moscow
Russia
60
„
F
‟ (fig. 65 ) – confirms that charging is over and battery is
fully charged.
After fast-charge mode completion executive charging circuit
cuts off automatically and green LED will flash every 2 sec.
NOTE 2: One can leave fully charged battery coupled to the
Charger after charging completion for a long time.
BATTERY REFRESH MODE.
New NiCad and NiMH battery or battery that was out of use
for a long time needs special treatment: refreshing - i.e. several
consecutive charge/discharge cycles.
That allows to „refresh‟ the battery, in other words, to recover
battery‟s full charging capacity. Refreshing process depends on
general battery status and might take up to several hours.
Couple the battery
to the Charger and
press
„Refresh‟
button to start the
refreshing mode.
Fig. 66
