Studer Innotec SA
BSP
User manual
V1.3
15
The values available are the following:
Name of the value
Unit
Description
Battery voltage
Vdc
-
Battery current
Adc
-
State of Charge
%
State of charge indicated by the battery icon and
transmitted to the other devices.
Power
W
-
Time to go
hh:mm
During discharging, it indicates the time before it
reaches 0 %. This value is calculated on basis of the
present current. What it gives is an indication. A variable
energy consumption has of course a big impact on this
value. During charging, this value is undetermined.
Battery temperature
°C
Temperature used to calculating the battery state of
charge. Unless a BTS is connected to the Xtender and
therefore its value taken into account, this is the
temperature measured inside the BSP that will be used.
BTS temperature
°C
Temperature of a XT, VT or VS to which the BTS is
connected or ‘---‘ if not present.
Ah charged today
Ah
Charge supplied to the battery from midnight until now.
Ah discharged today
Ah
Charge supplied by the battery from midnight until now.
Ah charged yesterday
Ah
-
Ah discharged
yesterday
Ah
-
Total kAh charged
kAh
Charge supplied to the battery from the last reset to zero
of the battery history. See “Reset of battery history
{6003}” (p. 17).
Total kAh discharged
kAh
Charge supplied by the battery from the last reset to
zero of the battery history.
Total time
Days
Time since the last reset of the battery history.
Charge counting on the
user side
Ah
With this value, the user can measure the charge or
discharge of the battery according to his needs. This
counter, as well as the other two mentioned below in this
table, can be reset to zero by means of the parameter
“Connecting the communication bus {6031}” (p. 17).
Displays ‘---‘ above 65504.
Discharge counting on
the user side
Ah
Displays ‘---‘ above 65504.
Duration of the counting
on the user side
Hours
Displays ‘---‘ above 65504.
Manufacturer SOC
%
See {6055} and {6056}
