16
main encoder). The frequency ranges from 16 Hz to 400 Hz, with 16 Hz being default.
⑥
Insert
Press an effect module button to insert it prior to the channels EQ. Each effect module can
only be inserted in one place and the input channels allow for only one effect module to be
inserted. When a selected module is used in another channel or bus, a pop-up window will
warn: “The module can only be used once and it is already used by xxx. Are you sure you
want to use the module forcibly now? Yes / No”. Change the effect settings through:
SETUP
→
FX
→
click on the module to open a dialog for the effect.
Parametric EQ Subpage
This page is the same as for the MIC channels. Any settings will be applied to both channels
of the stereo signal.
Dynamics Subpage
In case of ST1 and ST2 this page is the same as for the MIC channels with any settings
being applied to both channels of the stereo signal. For S/PDIF and USB channels there is
no dynamic section.
Bus Send Subpage
In case of ST1 and ST2 this page is the same as for the MIC channel. For S/PDIF and USB
channels sending is limited to the stereo busses 5-8 and Master LR. For the mono busses,
effectively the sum of both sides of the stereo channel is sent to the bus. For the stereo
busses and Master LR, a balance is implemented instead of a Panning: center (50|50) of
BAL will send the left and right parts of the stereo channel to the corresponding left and
right parts on the Bus. Any other setting will attenuate one side of the stereo channel with,
e.g., (100|0) only sending the left part of the stereo channel to the left side of the bus and the
right part being muted.
Output Stage Subpage
This page is the same as for the MIC channels
