8
1
1
EN/06.2021 © STULZ GmbH – all rights reserved
air side connection
Downflow unit
To clarify the cable routing, the rear panels and the
side panels have been removed in the illustrations.
This is not necessary in practice.
The adapter plate and damper are already shown
in the illustration in their final position. However, it
is first necessary to connect the pre-installed cable
to the actuator.
The cable is already connected in the e-box and
routed along the left side wall and lies rolled up on
the filter element.
• Provide opening (1) with a rubber grommet from
the accessory pack.
• Place the assembly of adapter plate and damper
on the A/C unit and leave a free space on the
side with the actuator so that you can push the
free cable end from below through opening (1).
• Push the adapter plate into the final position and
readjust the cable.
• Cut the cable to length and connect it to the
actuator according to the enclosed manufactur
-
er‘s instructions.
Downflow unit, view from the left rear
Electrical connection of the actuator
wArning
Risk of bruising of limbs
Check that the power supply to the A/C unit is switched off so that the damper cannot be
started.
