35
7.5.1 General
There are 3 types of operation modes for the recorder, they are stand-by mode, recording
mode, and adjusting mode.
7.5.1.1 Stand-by mode
The date and time will be displayed after turn on the main power, and low battery symbol will
flash for charging and/or low battery as shown in Figure 27.
Figure 27
Note:
Call for service to replace the rechargeable battery if the exhaust battery symbol “ ”
presented after some cycles. After replacing and servicing, you have to set the date,
time and unit again.
7.5.1.2 Recording mode
a) Recording of the sterilization data is activated automatically after press “Start” button on
autoclave panel, and then the chamber temperature and flashing message “Rec” will be
displayed.
Figure 28
Note 1:
Insert a formatted USB flash drive before commencing a sterilization cycle.
Note 2:
If none of the USB flash drive being detected before commencing a sterilization
cycle, the warming message “E105: No USB memory” is presented and the
buzzer alarmed. This message will not affect the operation of sterilization
work because the data will be stored onto the built-in memory for one cycle.
Refer to “ 7.5.2.4 Download” for the further instructions to download the data
onto a USB flash drive.
b) After completing a sterilization cycle, the data will be stored to USB flash drive; and the
recorder returns to stand-by mode. The sequences of storage message are shown in
the Figure 29.
low battery
2019- Apr-02
13:30:30
Recording mode
Start R
26
°
C 0.03bar
Chamber temperature
Sterilization cycle indication
Chamber pressure
