16
6.2 Prepare Sterilization
A. Follow “4. Installation” to finish installation first.
B. Follow “4.2 Install the sterilizer” to make sure the water inside reservoir is sufficient.
C. Check the Pressure Gauge is reading ZERO, and then open the door by turning the door
knob 90° counterclockwise.
D. Place the items to be sterilized and the sterilization indicator strips (or biological indicator
into the basket as required as Figure 9.
Figure 9
Caution:
Before loading, ensure instruments are cleaned and rinsed.
Warning:
Refer to “11. Specifications” for the maximum permissible load. Failure to
follow these instructions may cause the sterilizer to malfunction and result in
an unsuccessful sterilization cycle.
E. Close the door and press Door handle.
F. Press the “POWER” switch to ON “I” position, the power indicator light should illuminate.
The “DOOR OPEN” indicator light should be off.
Put the sterilization items into baskets.
But the sterilization items don’t over
the basket.
