38
The sequence is in the order of Temperature - Pressure each time you press the “Set” button.
After entering the unit, press “Set” button returns to the Set manual, and then to choose “8.
EXIT” press “Set” button again returns to the stand-by mode as shown in Figure 32.
7.5.2.3 Remove USB
Caution:
The data may be damaged if not follow this operation to detach the USB flash
drive properly.
Press “SET” button in the stand-by mode and then press increase (
▲
) or decrease (
▼
) until
“3. Remove USB” displayed as shown in Figure 35.
Figure 35
Press “SET” button, you will be prompt “Please remove USB Memory”, and then remove the
USB memory safely. This message will be lasted until you have detached the USB memory.
Figure 36
Press "Settings" to return to the previous page, as shown in Figure 35. Then select "8. Exit"
and press "Set" to return to standby mode.
3. Remove USB
Please remove
USB memory
