DCX.Server/DCX.Client/DCX.NC
www.stute-engineering.de
C
h
a
p
ter
:
Q
ui
c
k S
tar
t
8
2.6
BASIC
configuration (DCX.Server &
DCX.Client)
2.6.1
First steps
DCX.Server software
Install the DCX.Server software at your MS-
Windows computer (see chapter 2.2)
Connect a USB-RS232 interface (38400 baud)
to your computer and the Behringer DCX2496
device
Switch on your DCX2496 device
Open the DCX.Server program
o
Press the button “Change COM port…”.
o
Select a COM port and press “OK”. The COM led shines green
Check the displayed “Server IP” address
o
Is it a valid IP of your local network?
o
E.g.
192.168.178.
23
DCX.Client software
Note: First enable Wi-Fi or cable network connection at your device!
Install the DCX.Client software at your computer or tablet/mobile phone (see chapter
2.2)
Open the program DCX.Client (DCX.Server should already started)
o
For the first start wait 20-30 seconds. The client searches for the DCX.Server
Note: Via the button “Find DCX.Server/NC” from the “Settings/Network” tab you check the
network connection to the DCX.Server.
2.6.2
Control your DCX2496 device
Follow the chapter “First steps”
Switch on your DCX2496 device
Open the DCX.Server software
Open the DCX.Client software
o
“Home” tab: Select the device ID of your DCX2496 (default= 1)
Alternative press “Find DCX devices…” to scan for DCX2496 devices
o
Press the button “Connect/Read DCX…” to connect the client with a DCX2496
The progress bar in footer displays the status of the DCX data import
o
The software is ready to control the DCX2496
E.g., select the tab “A B C Sum”. Change the dB gain of “In A”
Check the level at the Behringer DCX2496
