9
Energystar energy-saving light
OPERATING INSTRUCTIONS
GB
Notes on the place of installation
• Set up the light on a solid, level surface
(e. g. table or sideboard) close to a so-
cket.
• Make sure that there is no risk of it tipping
and that the cord does not pose a trip ha-
zard.
• Do not set up the light directly next to
another heat source and close to curta-
ins, drapes etc.
Assembly with clamp
1. Insert the pin of the lamp arm into the
holder on the clamp.
2. Mount the lamp on a solid, hard, even
board with parallel surfaces.
3. Ensure that the clamp is sufficiently
secured.
Assembly with stand
1. Insert the pin of the light arm into the
holder on the base.
Turning the light on/off
1. Insert the plug in a socket.
2. Arrange the light in the desired position.
3. Set the On/Off switch to
I
.
4.
Set the On/Off switch to O to turn off the
light.
Changing the bulb
CAUTION
Burn hazard!
Do not touch the casing or the
bulb with bare hands when in
use and after turning off the light, allow it
to cool before touching it.
1. Turn off the light and pull the mains plug.
2. Allow the light to cool off completely.
3. Pull the light bulb forwards out of the
lamp holder.
4. Insert the new bulb in the bulb holder.
Summary of Contents for Hansa 41-5010.523
Page 35: ...35 ...
