subzero.com
|
7
SITE PREPARATION
Preparation
Uncrate the unit and inspect for damage. Remove the wood
base and discard shipping bolts and brackets. Remove and
recycle packing materials. Do not discard the kickplate,
anti-tip bracket and hardware. Remove the kickplate by
removing the screws holding it in place.
IMPORTANT NOTE:
For drawer models, the upper drawer
has a control cable that must be disconnected before
removing the drawer. Refer to the illustration below.
Anti-Tip Bracket
WARNING
To prevent the unit from tipping forward, the anti-tip
bracket must be installed.
The back of the anti-tip bracket must be installed 24"
(610)
from the front of the unit (without panels).
Use all anti-tip bracket hardware as instructed for wood or
concrete floors.
IMPORTANT NOTE:
For wood or concrete floor applications,
if the #12 screws do not hit a wall stud or wall plate, use the
#8 screws and #12 washers with the wall anchors.
IMPORTANT NOTE:
In some installations the subflooring or
finished floor may necessitate angling the screws used to
fasten the anti-tip bracket to the back wall.
ANTI-TIP HARDWARE
1
Anti-tip bracket
12
#12 x 2
1
/
2
" pan head screws
4
3
/
8
"–16 x 3
3
/
4
" wedge anchors
12
#12 flat washers
4
#8–18 x 1
1
/
4
" truss head screws
4
Nylon Zip-it
®
wall anchors
Control cable (drawer models).
