BI SERIES
DRA
WER
EXISTING
DRA
WER
PA
NEL
BOTTOM
TRIM
SIDE TRIM
FILLER (2)
TOP TRIM
SCREWS
SCREW COVER
2
1
2
3
4
5
SCREWS
Figure 7. Drawer Component Installation
Built-In Series Overlay Door Panel Retro-Fit Kit - For Over/Under Models
(7003402, 7003403)
7007804 / Rev A / January, 2008
Page 2 of 3
SCREW COVER
HANDLE-SIDE TRIM
FREEZER DRAWER TRIM REMOVAL PROCEDURE
:
1. At the back right-hand side of the top drawer trim, insert a flat blade screwdriver into the notch in the screw
cover and pry the cover away form the top trim, disengaging it from the top trim (See Figure 4).
2. With a T-20, 6-lobe Torx type bit, extract the top trim mounting screws and pull the top trim from the drawer
(See Figure 5).
3. With a T-15, 6-lobe Torx type bit, extract the bottom trim mounting screws and pull the bottom trim from the
drawer (See Figure 6).
DRAWER COMPONENTS INSTALLATION PROCEDURE
(See Figure 7)
:
1. Install the new Freezer Drawer Bottom Trim reusing the screws just removed in step 3 above.
2. Install both Drawer Side Trim Fillers so that they overlap the side trim and hook up with the bottom Trim.
3. Install the existing 600 series drawer panel.
4. Reattach the top drawer trim.
5. Reinstall the screw cover.
Figure 4. Screw Cover Removal
DRA
WER
TOP DRA
WER
TRIM
Figure 5. Top Trim Removal
DRA
WER
BOTT
OM TRIM
Figure 6. Bottom Trim Removal
