8
SUB-ZERO BUILT-IN USE & CARE
REFRIGERATOR STORAGE
STORAGE DRAWERS
To remove a storage drawer in the refrigerator
section, pull the drawer out until it stops. Lift the
font of the drawer slightly and pull the drawer
straight forward. Refer to the illustration below.
IMPORTANT NOTE:
If the door is limited to a
90° door opening, the shallow door shelves will
need to be removed from the bottom of the door
in order to remove a drawer.
To reinstall, push the drawer slides back into the
refrigerator. Align the drawer with the slides,
then push the drawer straight back on to the
slides until it stops. The front of the drawer
should drop slightly and click when it is properly
engaged onto the slides.
DOOR SHELVES AND DAIRY
COMPARTMENT
The door shelves and dairy compartment are
adjustable within the guides of the door liner.
NOTE: Glass door models do not have door
shelves or a dairy compartment.
To remove a shelf or the dairy compartment, lift
it up and out from the bottom. To reinstall, push
it down into the guides. Refer to the illustration
below.
Refrigerator storage drawer
removal
Door shelf removal
Adjustable glass shelf removal
ACCESSORIES
Optional acces-
sories are available
through your
Sub-Zero dealer. To
obtain local dealer
information, visit
our website,
subzero.com.
ADJUSTABLE GLASS SHELVES
Be sure to read and understand the following
instructions before removing or adjusting
shelves. To remove or adjust shelves, first tilt the
shelf up at the front, then lift it up and out of the
tracks on the rear wall of the refrigerator. Refer
to the illustration below.
If the door is limited to a 90° opening, you'll
need to clear the door shelves in order to
remove a shelf. Lift and pivot the end of the shelf
nearest the door upward, and remove.
To replace a shelf, insert it in the tracks at the
rear of the refrigera tor with the front of the shelf
raised slightly. As you push the shelf in, lower
the front of the shelf until it locks into position.
IMPORTANT NOTE:
Always be careful in han-
dling glass shelves to prevent breaking or
scratching the interior.
ELECTRONIC CONTROL SYSTEM
SABBATH MODE (STAR-K)
All Built-In models feature the Sabbath Mode.
This is for certain religious observances where
the lights and ice maker function need to be
turned off.
To initiate Sabbath Mode, while the unit is on
press the
key pad so that OFF is visible in the
Control Center display panel. Your unit will be
off.
Then press and hold the
key pad for 10 sec-
onds. This will turn the unit back on and will dis-
able the lights and ice maker. To return the unit
to normal operating conditions, press and
release the
key pad.
If you have questions about Star-K compliance,
visit www.star-k.org.
VISUAL SERVICE DISPLAY
The Control Center monitors refrigerator and
freezer temperatures as well as the ice maker
system. If there is a temperature or ice maker
problem, you’ll be alerted by an illuminated or
flashing
indicator in the Control Center dis-
play panel. The
indicator may also be illumi-
nated if the condenser needs cleaning. Before
calling for service, please check and see if your
condenser area needs cleaning. See Condenser
Cleaning, page 13.
Glass shelves should warm to room
temperature before immersing in warm
water.
CAUTION