Sub-Zero Wolf WWD30, Service Manual

Page 14

Electronic Control Information

WARMING DRAWER WWD30

3-9

USER PREFERENCE SETUP

NOTE: 

Following changes must be made when unit is in “ON” mode.

Preset Change:

Changes can be made to presets by completing the following sequence.  Press “Power On/Off” key, then press pre-
set key you wish to change and hold for 5 seconds.  After 5 seconds, timer display, temperature display and “TIMER”
will illuminate and flash. Using “TEMP” up or down arrow keys, and/or the “TIMER” up or down arrow keys, change
the values to your own personalized presets.  After all settings are complete, press and hold the preset key being
changed for 5 seconds again.  Three quick tones will signify preset has been changed and unit will shut off.

NOTE:

“PROOF” mode can only be adjusted from 80°F to 120°F. 

NOTE: 

Unit will turn off after 30 seconds if no key presses are made.

NOTE: 

Changes to preset mode entered will be saved only if key being changed is pressed and held for 5 seconds

after making changes.

USER PREFERENCE OFFSETS  (UPO)

NOTE: 

Following changes must be made when unit is in “OFF” mode.

NOTE:

See Figure 3-20

 for a quick reference to keystrokes to enter modes and features.

Temperature Display Preference:

Control can be switched between Fahrenheit or Celsius by pressing and holding both “TEMP” up and down arrow
key for 5 seconds.  Use the “TEMP” Up or Down arrow key to change from °F to °C or °C to °F. 

 (See Figure 3-12)

NOTE: 

Press “Power On/Off” key to exit and save changes.

Display Contrast Change:

Display contrast can be adjusted by pressing and holding both the TIMER up and down arrow keys for 5 seconds.  
Use the “TIMER” Up and/or down arrow keys to change contrast from the preset.  

 (See Figure 3-13)

NOTE:

Contrast setting is from 0 to 15 with 15 being the darkest contrast setting.  Unit default is 7.

Press the “Power On/Off” key to exit and save changes.

NOTE: 

Unit will turn off after 30 seconds if no key presses are made.

TIMER

PROOF

LOW

PRESETS

HIGH

MED

TEMP

POWER
ON/OFF

PROOF

TEMP

TEMP

TEMP

ON TIMER

Figure 3-12.  Press TEMP up and down arrow key to enter. Press TEMP arrow up or down to change scale.

TIMER

PROOF

LOW

PRESETS

HIGH

MED

TEMP

POWER
ON/OFF

PROOF

TEMP

TEMP

TEMP

ON TIMER

Figure 3-13.  Press TIMER up and down arrow key to enter. Press TIMER arrow up or down to change scale.