Page 25
4-8
Component Access & Removal
WARMING DRAWER WWD30
Thermal Cutout
NOTE:
Electrical shock potential. Refer to warnings on
page 4-2.
The thermal cutout is mounted above and to the left of
the fan assembly on the inner back panel.
To remove the thermal cutout, begin by removing the
drawer and cavity baffle from the unit. Next, remove
unit from its installation position by extracting wood-
screws from sidewalls, then sliding unit out of the instal-
lation opening and unplugging from wall socket.
With needle nose pliers, disconnect elec-
trical leads from thermal cutout and power board. Push
the wire leads from thermal cutout and heating element
through grommet of fan mounting bracket. Continue by
extracting screws from outer back panel and remove
from unit.
inner panel. Pull the bottom of inner back panel out
first, then pull back at the top until thermal cutout is
accessible. The thermal cutout is riveted into position.
You will need to drill out the rivets to remove.
NOTE:
Use stainless steel screws when installing new
thermal cutout or rivets if available.
Power Cord
NOTE:
Electrical shock potential. Refer to warnings on
page 4-2.
The power cord enters the unit through a box mounted
in the left rear corner of the outer back panel. The
ground wire is secured to a screw which holds the elec-
trical box in place.
To remove the power cord, begin by removing the draw-
er from the unit. Next, remove unit from its installation
position by extracting woodscrews from sidewalls, then
sliding unit out of the installation opening and unplug-
ging from wall socket. Continue by extracting screws
from outer back panel and tilt away from unit.
Remove nut from heyco fitting at top of
electrical box and grounding wire from outer back panel.
Pull wire with heyco fitting attached, out of electrical box
and remove from unit.
Figure 4-21. Back Panel Removal
Figure 4-19. Remove Unit From Installation
Figure 4-20. Back Panel Removal
Thermal Cutout
Back Inner Panel
Quick Disconnect
Heyco Nut
Remove Screws
