Subaru EA175V, Instructions For Use Manual

13

EN
FR
DE
NL
ES
IT
PT
GR
NO
SE
FI
DK
RU

2. STARTING

Pull the starter handle slowly until resistance is felt. This is the “compression” 
point. 

Return the handle to its original position and pull swiftly. Do not pull the rope 
out all the way. After starting the engine, allow the starter handle to return to its 
original position while still holding the handle.

FOR ELECTRIC STARTER MODELS.

Insert the key into the key slot and set it at the “ I ” (ON) position. Turn it to the right (START position) to start the engine.

■

Do not operate the electric starter continuously for more than 5 secounds, even if the engine dose not start.

■

If the engine failed to start, set the key to the “ I ” (ON) position and wait for about 10 secounds before retrying. 

■

Never turn the key switch to the START position while engine is running.

(4) Push primer bulb three times.

 CAUTION

If the engine is already warm, do not push the primer bulb.

3.  THROTTLE SETTING

FOR VARIABLE ENGINE SPEED MODEL

(1)  After the engine starts, move the throttle control lever to the HIGH position 

❸

.

(2)  Turn the throttle control lever for the required engine speed. 

(Between 

❷〜❸

)

❶

 STOP

❷

 LOW

❸

 HIGH

FOR FIXED ENGINE SPEED MODEL

Let the engine warm up without using the machine (no load) for a couple of 
minutes.  

The engine speed is adjusted at the factory to operate a speci

fi

 ed speed.  

Do not attempt to alter the speed as it may cause damage to the engine.

1

2

3

4. STOPPING

FOR MOWER

(1)  Release the brake wire. (Brake : ON)

❶

 Disengage (Brake : OFF)

❷

 Engage  (Brake : ON)

1

2

EA175̲190V̲en̲EU7482.indd   13

EA175̲190V̲en̲EU7482.indd   13

2013/01/15   20:35:31

2013/01/15   20:35:31