12 OF 14
PART NUMBER
H001SFL400
ISSUE
01
DATE
25 Jul 2018
SUBARU OF AMERICA
PANEL RE-ASSEMBLY
8
1. Plug the yellow electrical connector into the airbag/knee bolster. Verify that the yellow connector is fully seated.
Failure to seat the connector lock could result in the instrument cluster airbag light remaining illuminated. Reinstall
the airbag/knee bolster and torque the two (2) 10mm nuts to 7.5 Nm +/- 2 Nm (0.76 Kgf-m +/- 0.2 Kgf-m, 5.5 ft-lbs
+/- 1.5 ft-lbs).
2. Re-install the steering column shroud and secure in place with two (2) Phillips screws.
3. Re-install the driver’s right side lower dashboard panel and secure with one (1) Phillips screw.
4. Plug in any previously removed connectors and re-install the driver’s left side lower dashboard panel.
5. Re-install the one (1) Phillips screw on the left side of the dashboard that secures the lower dashboard panel in place.
6. Re-install the left side dashboard panel.
7.
Re-install the passenger’s side ornament panel by engaging the four (4) pressure clips and one (1) fi nger clip.
8. Re-install the right side dashboard panel by engaging the four (4) pressure clips.
9. Re-install the glove box and strut.
10. At the end of the installation, insert the Quick Reference Cards into the Owner’s Information Kit.
7
UNDER HOOD WARNING LABEL MOUNTING
1. Using alcohol, clean the top of the air intake plenum,
near the radiator core support.
2. Remove the release liner from the under hood warning
label and secure to the top of the air intake plenum,
as shown. (FIGURE FF)
FIGURE FF
WARNING: / ADVERTISSEMENT
WARNING: / ADVERTISSEMENT