5 OF 14
ISSUE
01
DATE
25 Jul 2018
SUBARU OF AMERICA
PART NUMBER
H001SFL400
1/2”
- Do Not Remove 1/2” Section -
5
1. Locate the glove box inner cover and remote engine
start ECU. Using alcohol, clean the back side of the
glove box inner cover and ECU, as shown.
(FIGURE M)
2. Using the supplied double sided tape, remove the three
(3) small release liners and attach the tape to the glove
box inner cover. Ensure the tape is positioned against
the vertical character line and fl at against the multi-level
inner cover, as shown. Press fi rmly in place for at least
30 seconds. (FIGURE N)
NOTE: Ensure the double sided tape is positioned
away from any obstructions on the glove box inner
cover.
3. Using a ruler, measure and mark a straight line 1/2”
down from the top of the double sided tape, as shown.
(FIGURE N) Using a sharp utility knife and ruler, score
the release liner of the double sided tape on the straight
“dashed” line.
NOTE: Score the release liner only. Do not score
through the double sided tape.
REMOTE ENGINE START ECU MOUNTING
FIGURE M
Vertical
Character
Line
Obstruction
Clean with
Alcohol
FIGURE N
