6 OF 14
PART NUMBER
H001SFL400
ISSUE
01
DATE
25 Jul 2018
SUBARU OF AMERICA
5
4. Remove the larger/lower section of the release liner
from the double sided tape. (FIGURE O)
5. Attach the remote engine start ECU to the double sided
tape. Ensure the corner of the ECU, closest to the white
8-pin header, is fl ush with the upper left corner of the
exposed double sided tape, as shown. (FIGURE P)
Press fi rmly in place for at least thirty (30) seconds.
NOTE: Ensure the 1/2” upper section of the double
sided tape is NOT covered by the ECU.
6. Using alcohol, clean the lower, front side of the ECU,
as shown. (FIGURE P)
7. Remove the release liner from the one (1) supplied wire
harness clip and attach it to the lower, front side of the
ECU, as shown. Press fi rmly in place for at least ten
(10) seconds. (FIGURE Q)
8. Using one (1) of the supplied 39cm tie wraps, secure
the remote engine start ECU to the glove box inner
cover. Trim off the excess tie wrap. (FIGURE Q)
REMOTE ENGINE START ECU MOUNTING, continued
FIGURE O
FIGURE P
1/2”
- Do Not Remove 1/2” Section -
Mount Corner
of ECU Flush
with Corner
of Exposed
Foam Tape
FIGURE Q
1/2”
- Do Not Remove 1/2” Section -
1/2”
- Do Not Remove 1/2” Section -
Clean with
Alcohol
