9 OF 14
ISSUE
01
DATE
25 Jul 2018
SUBARU OF AMERICA
PART NUMBER
H001SFL400
6
4-PIN & 2-PIN PRE-FIT CONNECTIONS
9. Locate and release the vehicle’s 4-pin and 2-pin
pre-fi t connectors secured to the vehicle’s wire
harness with breakaway tape near the dash wall
and to the left of the brake pedal assembly.
(FIGURE
Y)
10. When the vehicle’s 4-pin and 2-pin pre-fit
connectors are free from the breakaway tape,
unplug and discard the 2-pin mating connector/
wire jumper. (This is used for the power window
interrupt circuit).
11. Plug the remote engine start wire harness 4-pin
and 2-pin connectors into the corresponding pre-fi t
connectors and secure to the vehicle’s wire harness
with one (1) of the supplied 39cm tie wraps.
Trim off the excess tie wrap. (FIGURE Z)
REMOTE ENGINE START WIRE HARNESS CONNECTIONS, continued
FIGURE Y
FIGURE Z
Brake Pedal
Assembly