Operation Check
1. Confirmation of the Installation.
Before operation confirmation, review the Installation Instructions and make sure that all connections are
correct. To make sure that everything in the vehicle is working properly, you can check by connecting the
Subaru SSM. If it has problems, you will need to fix them first.
2. Operation Confirmation
Close the hood, place shift lever in park [P] with parking brake set, turn off lighting switch, turn "ENGINE
START STOP" Button to OFF get out of the car, and close all of the doors.
Operation
Confirmation point
Checking point if operation failed
1
Press the LOCK button of the
vehicle’s remote twice within two
seconds, then press and hold the
LOCK button for more than three
seconds.
·
The horn sounds once.
·
The Engine starts.
·
After the engine starts, the horn
sounds once at the same time as
all the front position lights, tail lights
flash once.
·
All marker lights, tail lights turn on
afterwards.
"Check C" on page 28
2
Press and hold the LOCK button of
the vehicle’s remote for more than two
seconds.
·
Engine stops.
·
All marker lights, tail lights turn off.
"Check E" on page 33
3
Sit inside the vehicle and close the
door, then perform step 1 again to
Smart Engine Start.
·
Refer to Step 1.
-
4
Push the automatic window switch.
·
The window does not open.
Check wiring diagram for connection of
connector G with signal specification
for PWI on pages 36-37.
5
Pull the hood release lever and fully
open hood while the engine is running.
·
Engine stops.
Check signal specification for HOOD
on page 37.
6
Close the hood, press the "ENGINE
START STOP" Button to IG-ON, and
push the automatic window switch.
·
The window opens.
Check wiring diagram for connection of
connector G with signal specification
for PWI on pages 36-37.
7
After reassembly of the vehicle,
perform function checks on all
electrical components that were
disconnected during the installation
of this accessory.
·
It works correctly.
Confirm that all connectors are plugged
in properly.
- 22 -
