Is the battery terminal connected?
Is the Ignition ON?
Are connectors B and C on the wiring diagram (page 36)
connected? Is the connector plugged in properly?
Disconnect and reconnect the connectors, and try to register again. Were you able to register?
Check the signal for RREG on harness checks on page 37. Was the problem solved?
Are connectors A and F on the Wiring Diagram
(page 36) connected? Is the connector plugged in properly?
Connect it
Try to register again.
Connect them.
The SES ECU may have problem. Replace it, and register again.
If registration failed, replace the wiring harness and register again.
Register again.
Connect them.
Press the "ENGINE START STOP" Button twice to turn ignition ON.
The registration was successful.
Yes
No
Using the harness checks on page 37, please check these sB, GND, IG. Was problem solved?
Check A
Yes
Yes
No
Yes
Yes
No
No
No
Yes
Yes
No
No
- 26 -
