HOOD SAFETY SWITCH MOUNTING
1. In the engine compartment, locate the 2-pin pre-fit
hood safety switch connector secured to the wire
harness with breakaway tape in front of the shock
tower on the passenger’s side of the vehicle.
(FIGURE Y)
2. Plug the supplied remote start harness 10” hood
safety switch wiring harness to the vehicle’s 2-pin
pre-fit connector.
3. Mount the hood safety switch bracket to the
vehicle’s fender in the predrilled hole using the
supplied 10mm bolt (FIGURE Z). Torque the bolt to
10.8 Nm +/- 2 Nm (1.10 Kgf-m +/- 0.2 Kgf-m, 8 ft-lbs
+/- 1.5 ft-lbs).
4. Securely mount (snap-in) the supplied hood safety
switch in the bracket and plug the 2-way female
connector of remote start harness 10” hood safety
switch wiring harness to the base of the hood safety
switch. (FIGURE Z)
PART NUMBER
H001SXA000
8 OF 10
ISSUE
01
DATE
03/1
4
/06
SUBARU OF AMERICA
9
FIGURE Y
FIGURE Z
T
UNDER HOOD WARNING LABEL MOUNTING
1. Using alcohol clean the top of the air intake plenum.
2. Remove the adhesive backing of the underhood
warning label and secure to the top of the air intake
plenum. (FIGURE AA)
10
WARNING: / AVERTISSEMENT
This vehicle is equipped with a remote controlled engine starter.
To reduce the risk of serious Injury or death, switch engine starter
system into service mode and disconnect the vehicle battery
before performing any service on the vehicle.
Ce véhicule est doté d'un démarreur à distance. Pour réduire les
risques de blessures graves ou mortelles, mettre le démarreur à
distance en mode service et débrancher la batterie du véhicule
avant d'effectuer des travaux d'entretien sur celui-ci.
FIGURE AA
