TACHOMETER IDLE SPEED PROGRAMMING
1. Open driver’s door (leave open throughout programming operation).
2. Turn the ignition key to the ON or RUN position.
3. Press and hold the momentary programming button for approximately 10 seconds until the
vehicle’s horn honks (3) times.
4. Release the momentary programming button.
5. Press and release the momentary programming button. The vehicle’s horn will honk (4)
times.
6. Press and release the vehicle’s brake pedal (1) time. The horn will honk (1) time to
indicate that the system has entered tachometer idle speed programming mode.
7. Start the vehicle with the ignition key. The RES system will begin honking the vehicle’s
horn 1 time every 3 seconds to indicate a valid tach signal.
8. When the engine has settled to a normal idle speed (normally 750-1000 RPM), press and
release the brake pedal (1) time. The horn will honk (2) times to indicate the system has
exited tach idle speed programming.
Be sure that the vehicle has maintained 750-1000 RPM idle speed prior to exiting
tachometer idle speed programming.
9. Turn the ignition key to the OFF position.
SYSTEM POWER-UP
After all connections are complete, turn the ignition key to the ON or RUN
position and re-connect the vehicle’s negative battery terminal.
PART NUMBER
H001SXA000
9 OF 10
ISSUE
01
DATE
03/1
4
/06
SUBARU OF AMERICA
11
12
