7 OF 12
ISSUE
-
DATE
10 Jan 2018
SUBARU OF AMERICA
PART NUMBER
H001SXC100
5
8. Using two (2) of the supplied 39cm tie wraps,
secure the remote engine start harness to the
vehicle wiring harness. Attach one (1) tie wrap to
the right of the factory tie wrap at the white tape ring
on the remote engine start harness. Attach one (1)
tie wrap to the right of the steering column, above
the air duct at the white tape ring on the remote
engine start harness. (FIGURE Q)
9. Using alcohol, clean the air duct surface to the
left of the center console, as shown. Remove the
release liners from two (2) of the supplied wire
harness clips. Apply to the air duct and press fi rmly
in place for at least ten (10) seconds. (FIGURE R)
NOTE: Ensure the openings of the wire harness
clips face upward.
10. Route the remote engine start harness toward the
passenger’s side of the vehicle behind the center
console area. Secure the remote engine start
harness to the previously installed wire harness
clips. (FIGURE S)
REMOTE ENGINE START WIRE HARNESS CONNECTIONS / ROUTING, continued
FIGURE Q
FIGURE R
FIGURE S
Accelerator
Pedal
Accelerator
Pedal
Hose Port
Hose Port
Factory
Tie Wrap
Steering
Column
