Subaru H011SAJ400, Installation Instructions Manual

7 OF 11

PART NUMBER

H011SAJ400

ISSUE

00

DATE

21 Apr 2013

SUBARU OF AMERICA

7

1. Locate the vehicle’s automatic transmission (A / T) module mounted

to the left side of the steering column.  (FIGURE V)

2. Route the previously installed windshield mounted antenna harness

and previously installed remote start pre-fit jumper harness towards

the A / T module and plug into the corresponding connectors on the

remote start control module (FIGURE W).   Route the remote start

ignition harness towards the A / T module and plug into the

corresponding connector on the remote start control module

(FIGURE W).  Double check all connectors to ensure a secure fit.

3. Secure the remote start control module to the left side of the A / T

module using the supplied velcro making sure the remote start ignition

harness connector is facing down (same direction as the A / T module

connector).  (FIGURE X)

4. As a secondary mounting provision, secure the remote start control

module to the A / T module using the supplied 21” tie wrap (route the

tie wrap between the 12-pin and 5-pin connectors on the remote start

control module and through the right side of the A / T module bracket).

(FIGURE X)

5. Using the supplied 8” tie wrap, secure excess remote start jumper

harness and antenna harness wiring to the existing vehicle wiring near

the prefit connectors behind the fusebox.  (FIGURE Y)

6. Using a supplied 8” tie wrap, secure the mated remote start harness

6-pin male and vehicle’s 6-pin female connectors to the factory ignition

harness.  (FIGURE Z)

7. Route the remote start ignition harness down the right side of the

steering column following the factory ignition harness and secure to

the factory ignition harness in two (2) places using the supplied 8” tie

wraps (FIGURE Z).

NOTE: After the remote start control module has been mounted

and all wiring secured, operate the tilt / telescopic fully to ensure

that the new components do not interfere with operation of the

tilt / telescopic feature.

REMOTE START CONTROL MODULE MOUNTING

FIGURE W

FIGURE X

Ignition Harness
Connector

Jumper Harness
Connector

Antenna Harness
Connector

FIGURE V

A/T Module

Brake Pedal

A/T Module

Brake Pedal

Tie Wrap

FIGURE Z

FIGURE Y

RES Module